New target - motors ok, UART1, 2, softserial defined, only rx1 under cli -> resource

[twoz12]

I'am trying to create a new target, which is very similar to the FLYWOOF411_V2. Changing the values for the motors & timers in target.c works and the motors are visible in the cli. UART 1 and 2 use the same ports as the new flight controller in the target.h, but I only can see A03: SERIAL2 UART RX in the CLI. INAV shows UART1, 2 and Softserial under Ports. I don't see any conflicting Ports. They all used only once and everthing else seems to work (Mag, Baro, voltage, rx), but of course not UART 1 (GPS). Do the UART's have to be defined again in the target.c or somewhere else to show up in the CLI?

Thank you

[twoz12]

I figured it out. rx, tx show only up in the CLI, when the devices are enabled under Ports and in case of the GPS module under Configuration as well.