Skip to content

linux-usb.md

Latest commit

 

History

History
80 lines (59 loc) · 2.48 KB

linux-usb.md

File metadata and controls

80 lines (59 loc) · 2.48 KB
Raw
title GNU/Linux installer preparation for Developerbox
permalink /documentation/enterprise/developerbox/installation/linux-usb.md.html

GNU/Linux Host

This section show how to prepare a bootable USB stick.

  • Step 1: Prepare USB stick
  • Step 2: Find USB stick device name
  • Step 3: Recall download location
  • Step 4: Go to directory with ISO Installer Image folder using Terminal
  • Step 5: Install image onto USB stick

Step 1: Prepare USB stick

  • Ensure data from USB stick is backed up
  • Everything on USB stick will be lost by the end of this procedure.

Step 2: Find USB stick device name

  • Use host computer
  • Open "Terminal" application
  • Remove USB stick from host computer and run the following command:
$ lsblk
  • Note all recognized disk names
  • Insert USB stick and run the following command (again):
$ lsblk
  • Note the newly recognized disk. This will be your USB stick.
  • Remember your USB stick device name, it will be needed in Step 5.

Step 3: Recall Download Location

  • Locate USB stick install file from Downloads page.
  • This file will be needed for the next step.

Step 4: Go to directory with USB Stick Install Image folder using Terminal

  • Use host computer
  • Open "Terminal" application
  • cd to the directory containing your USB Stick Install Image
$ cd <directory>

#Example:
#<directory> = /home/YourUserName/Downloads
#For this example we assume the "USB Stick Install Image" is in the Downloads folder.
$ cd /home/YourUserName/Downloads

Step 5: Install image onto USB stick

Checklist:

  • USB stick inserted into host computer
  • Recall USB stick device name from Step 2
  • From within the correct directory, using the Terminal execute the following commands:

Execute:

$ sudo dd if=YourInstallerImage.iso of=/dev/XXX bs=4M oflag=sync status=noxfer

Note:

  • if=YourInstallerImage.iso: should match the name of the image that was downloaded.
  • of=/dev/XXX: XXX should match the name of the USB stick device name from Step 3. Be sure to use the device name without the partition.
  • This command will take some time to execute. Be patient and avoid tampering with the terminal until process has ended.
  • Once USB stick is done flashing, remove from host computer and set aside.

Congratulations! Your USB stick is ready. Switch back to the Installation Guide to boot into the installer!