Why another?

I know that someone done this on the pico.

But this one run at 30fps without any cut content.

Hardware requirement

You will need a variant of the pico with 16MB of flash to use this.

SSD1306 I2C OLED 128x64

Note

I use pin 16 for SDA and pin 17 for SCL, change the parameters in main.cpp to your setup.

You may have to change PICO_BOARD in CMakeLists.txt file to your board specific.

I use weact_studio_rp2040_16mb board.

The uf2 file I built is 8.7MB. However the elf file is only 4.7MB.

It might be possible to optimize and cram this into 8MB flash board.

How 2 build

1. Install Pico C SDK to your PATH, or in this directory.
2. Create build directory mkdir build && cd build
3. cmake ..
4. If cmake run without issue, you can proceed to build make -j 8
5. After make finish build, flash the .uf2 file to your pico.

Link

https://youtu.be/89mWeVJCcXk