Support for stm32f030f4p6

[mirko]

Hello,

I'm having two cheap STM32F030F4P6 boards and an STM32F103 board.
BMP is flashed with latest firmware 1.9.0-rc1.
Connecting VCC-ref, GND, SWDIO and SWDCLK to the STM32F103 board and running monitor swdp_scan correctly detects the targets.
When connecting the two (one at a time, obviously) STM32F030 based board the same way, though, they are not detected.
All I see is SW-DP scan failed! when running monitor swdp_scan.
Is this to be expected? Is support missing for the STM32F030 series?
What could I be doing wrong? What could I do to eventually connect to those via SWD via my BMP?

[dragonmux]

Most likely you're being affected by #1359 which has a fix for it merged on main

[mirko]

Thanks, that sounded wonderfully easy.
Unfortunately I'm still having then very same issue with v1.8.2 :/

[dragonmux]

Could we ask for you to try a debug build of main (strip out a few unused targets from src/Makefile to get the build to fit, build with make PROBE_HOST=native ENABLE_DEBUG=1) and get a trace from the debug serial port please? Run monitor debug_bmp enable before doing the scan and the debug build of the firmware will log to the secondary USB serial port what it's doing.

[dragonmux]

We do believe this issue has been fixed though this is still pending testing - if in a couple of weeks we still have not had a response, we will close this as fixed in either v1.10 or on main.