open source repo just for rusEFI Hardware
See also https://github.com/rusefi/rusefi/tree/master/hardware
Many adapters are available assembled at https://shop.rusefi.com
Connector on one side, screw terminals or pads for your own harness on the other
- 24 pin generic 24 pin to three connectors
- 135 pin Subaru single connector (3D models only)
- 154 pin Volkswagen Audi VAG 284617-1
More "connect into wires" breakouts (35 to 134 pin: Mazda, Chrysler NGC, Mitsubishi, Motronic, Ford EEC-IV, VAG, BMW) live in the main repo at https://github.com/rusefi/rusefi/tree/master/hardware
Vehicle-specific adapters keep the original harness intact: stock ECU connector on one side, superseal into a rusEFI ECU on the other
- 24 pin superseal same as 24 pin but going into superseal
- 112 pin Bosch ME17 (rev A)
- 121 pin Ferrari/Maserati F136 engine
- 154 pin Hyundai/Kia 1.6 GDI PB (pinout)
- 198 pin Ford Mustang Coyote (pinout)
- Mazda Miata NC (pinout)
- Mitsubishi Lancer Evo X
- Mitsubishi Mirage
- Subaru 2011 (vehicle pinout, adapter pinout)
- 154 pin Volkswagen Passat 2.0 MED9.1 GDI
- ZF 8HP transmission installation board, solders in place of the stock TCU
Vehicle connector pinouts (no board, just connectors/*.yaml for interactive pinouts):
- BMW N52 146 pin (pinout)
- BMW N54 146 pin (pinout)
- Honda OBD1 64 pin + 76 pin (pinout)
- Toyota JZA80 Supra MK4 E9/E10
- Toyota JZA90 Supra MK5
- Jatco transmission
- Kawasaki motorcycle
- A4988 stepper motor driver
- L9779WD ASIC breakout
- MC33810 ASIC breakout
- TLE9104 ASIC breakout
- LM1949 low impedance injector driver
- IR2302 test board
- VR-Hall VR/Hall conditioner
- NCV1124 VR test module
- frequency divider
- quad IGBT and superseal IGBT ignition drivers
- stm32 Brain board 48pin
- uaBrain GM E38 hw-uaBrain module carrier for GM E38 (draft)
- GDI-4ch, GDI-6ch, GDI-STM direct injection drivers
- lambda-x2, wideband-F103 wideband controllers
- CDI-test, stim, digital-inputs test and QC boards
Frankenso, Frankenstein and other legacy designs are in classic-designs
Depends on libraries from https://github.com/rusefi/kicad-libraries
If you git clone be sure to also
git submodule update --init