Set parameters

Solar2MQTT can forward raw inverter commands. This is powerful, but dangerous.

Warning: commands are not syntax checked. Wrong commands can misconfigure the inverter.

MQTT

Send commands to:

<MQTT topic>/DeviceControl/Set_Command

Read the answer from:

<MQTT topic>/DeviceControl/Set_Command_answer

The latest answer is also stored in:

RawData/CommandAnswer

Open Debug and use the Command Sender field.

Typical PI serial examples:

Simulator commands are not stored. After reboot the device returns to normal hardware mode.
Raw command answers are visible in the Debug page, MQTT answer topic and debug report.
If you are unsure about a command, do not send it.

If something does not work, start with wiring, settings and the Debug page.

Solar2MQTT is a community project. Some devices work immediately, others need a little troubleshooting and a good debug report.